Freeze the requirement before fabrication
Record the target application, supply voltage, power, vessel, operating cycle, controls, enclosure, environmental assumptions and acceptance criteria. Unrecorded changes during a prototype make later failures difficult to diagnose.
- Approved requirement brief
- Interface and responsibility list
- Reference cookware or vessel set
- Defined operating and abnormal test conditions
Validate the complete assembled appliance
Bench testing a generator is not enough. Test the final airflow path, wiring, sensor positions, clearances, vessel relationship and controls inside the real enclosure.
- Low-, medium- and full-power operation
- Repeated heat-up and recovery cycles
- Sustained duty at realistic ambient conditions
- Protection and error-response checks
- Temperature records for the generator, coil and critical wiring
Turn assembly knowledge into controlled work
Document cable routing, connector identification, fastener requirements, sensor placement, coil gap, airflow clearance and inspection points. The objective is to reduce dependence on one technician’s memory.
- Assembly work instruction
- Incoming and in-process inspection points
- Commissioning and final-test record
- Serial or batch traceability
Run a pilot build before volume production
A small pilot exposes variation in fabrication, assembly time, component handling and test repeatability. Resolve these findings before fixing the production version and releasing larger quantities.
Protect version and service continuity
Lock the approved BOM, firmware or control version, drawings and acceptance criteria. Define critical service parts and a change-review process so production replacements do not silently alter performance.
- Approved platform version
- Critical spare-parts list
- Change notification and approval path
- Field issue record linked to the product version
Common project questions
Can a commercial induction SKD platform be selected by power alone?
No. Power, voltage, cooking task, vessel, coil geometry, cooling, controls and local assembly scope need to be reviewed together.
Are detailed BOMs and drawings published online?
No. Customer-specific technical files are controlled within an active project.
This guide explains selection logic. Final specifications depend on the confirmed appliance, electrical supply, cookware or vessel, duty cycle and integration design.